Cross Stitch Mistakes and How to Fix Them
8 November 2026 · 4 min read · By Crosserly
Every stitcher miscounts, tangles a thread or picks the wrong shade now and then. Most mistakes take a few minutes to fix by unpicking a few stitches, and some are fine to leave. Here are the common ones, how to fix each, and how to stop them happening again.
Miscounting
The classic: one stitch lands in the wrong square, and everything you stitch from it is out by one. You often only notice when two shapes do not meet up.
- Fix it: unpick back to the miscounted stitch and restitch from there.
- Or work round it: if a whole shape has moved by one square and still looks right, adjust the stitches around it instead of unpicking.
- Avoid it: count twice, stitch once. Count from a stitch you have already made, check against the bold lines every 10 squares, and tick off areas on the chart as you finish them.
Some stitchers sew a light grid onto the fabric every 10 squares in a contrasting thread, matching the bold lines on the chart, and pull it out at the end. It makes big charts much easier to count.
Knots and tangles
Thread twists a little with every stitch. Too much twist and it curls back on itself and knots.
- Let the needle hang: every few stitches, let it dangle from the work so the thread unwinds.
- Use shorter lengths: about 45 cm (18 in) tangles far less than an arm’s span.
- Separate the strands one at a time, then lay them back together, even when you need two.
- Catch a knot early: ease it open with the needle tip while it is loose. If it has pulled tight, cut the thread, take the end to the back, tuck it under nearby stitches and start a fresh length.
Do not tie knots to start or end a thread, either: they make lumps and can pull through. How to start cross stitching shows the knot-free way.
The wrong colour
Two similar shades are easy to mix up, especially in the evening under warm lamplight.
- Fix it: unpick the stitches in the wrong colour and restitch. One stray stitch in a big area of similar shades may not show at all, so step back and look before you unpick.
- Avoid it: keep each thread on a card or bobbin labelled with its number, check the key before each new colour, and stitch close shades in daylight. Ways to organise your floss help here.
If you stitch with Crosserly’s Stitch Assist, it warns you when two threads in the pattern look alike, so you know where to slow down.
Crosses facing different ways
Each X has a bottom stitch and a top stitch. If some top stitches lean one way and some the other, light catches them differently, and those stitches look patchy even in the right colour.
- Fix it: unpick just the top stitch and redo it in the right direction. The bottom stitch can stay.
- Avoid it: choose one direction for the whole piece. Working half crosses along a row, then coming back to finish them, keeps all the tops matching.
Dark threads showing through, and puckering
Carrying a thread across the back to the next stitch of the same colour is called travelling. Over a long gap, a dark thread shows through light fabric as a faint line.
- Fix it: carefully snip the long thread on the back, then tuck both cut ends under nearby stitches of the same colour.
- Avoid it: if the next stitch is more than about 3 squares away, end the thread and start again, or run it under stitches already on the back.
Puckering is fabric that wrinkles around stitches pulled too tight. Ease the worst ones looser with the needle tip and keep a lighter hand from then on. A gentle wash and a press face down on a towel often relax mild puckering: how to frame cross stitch covers washing and pressing.
How to unpick safely
Stitchers call unpicking frogging, because you “rip it, rip it”, which sounds like a frog. Go slowly: it is easy to snip or stretch the fabric.
For a few stitches, take the needle off the thread and use its tip to lift each stitch out, in the reverse order you made them. For a bigger area:
- Turn the work over and snip the threads on the back with small, sharp scissors, a few at a time, sliding the blade under the thread and never under the fabric.
- Pull the short pieces out from the front with tweezers.
- Lift the fuzz left in the holes with a strip of sticky tape.
- Restitch with a fresh length. Unpicked thread is worn and fuzzy, so do not reuse it.
Tip: Not ready to unpick? In Stitch Assist you can flag a mistake on the chart to fix later, so you keep stitching without losing track of where it was.
Crosserly is a free cross stitch pattern maker. Turn a photo or a few words into a chart in real thread colours, or draw your own, then print it or follow it on your phone.
Questions
Can you reuse thread after unpicking cross stitch?
It is best not to. Unpicked thread is worn and fuzzy, and it will look different from the stitches around it. Cut a fresh length instead.
Does it matter which way cross stitches cross?
Which way you choose does not matter, but it should be the same everywhere. Top stitches that lean different ways catch the light differently and look patchy.
Should I fix every mistake?
No. If you cannot spot a mistake from arm’s length, nobody else will. Fix the ones that change the picture, such as a wrong colour in a face or a shape that no longer lines up, and let the rest go.
Read next
- How to Start Cross Stitching With No Experience: A step-by-step roadmap for your very first cross stitch: what to buy, how to find the middle, your first stitch, finishing a thread, and what to stitch next.
- What Do I Need to Know Before Starting Cross Stitch?: The handful of things every new stitcher wishes they knew first: how a chart works, fabric counts, strands, the hoop question, and why your back can be messy.
- How to Organise Your Floss Stash and Supplies: Bobbins, boxes, rings and lists: simple ways to sort your floss, keep track of what you own, store fabric and patterns, and stop buying the same thread twice.
All blog posts · Guides: Photo to pattern guide · Cross stitch app for beginners · PDF charts on iPhone