How to Tell If Your Cross Stitch Fabric Is 11ct or 14ct
8 November 2026 · 4 min read · By Crosserly
Lay a ruler along one row of the fabric and count the squares in one inch (2.54 cm). Eleven squares means 11-count, fourteen means 14-count. On evenweave or linen, count the threads in an inch instead: that number is the count, and you halve it to get stitches per inch when you stitch over 2 threads.
What the count is, and what you need to measure it
The count is how many squares (on Aida) or threads (on evenweave and linen) fit in one inch. You will see it written as 14-count, 14ct or 14 count. The higher the number, the smaller the squares, and the smaller your stitches.
- A ruler or tape measure with inches. A centimetre one works too: see the table below.
- Good light, by a window or under a lamp
- A pin or a blunt needle, to touch each square as you count
- A magnifier, if the fabric looks fine (16-count and up)
How to count Aida
- Lay the fabric flat on a table. Smooth it out, but do not stretch it.
- Line the ruler up along one straight row of squares, with 0 at a hole.
- Count the squares, not the holes, up to the 1 inch mark. Touch each one with the pin so you do not lose your place.
- Count again in a different spot, and once in the other direction, from top to bottom.
- If you land between two numbers, count over 2 or 3 inches and divide. 42 squares in 3 inches is 14-count.
Squares in an inch, and in 10 cm
| Count | Squares in 1 inch | Squares in 10 cm | One square |
|---|---|---|---|
| 11-count | 11 | about 43 | 2.3 mm |
| 14-count | 14 | about 55 | 1.8 mm |
| 16-count | 16 | about 63 | 1.6 mm |
| 18-count | 18 | about 71 | 1.4 mm |
Only have a centimetre ruler? Count the squares in 10 cm and compare with the table. You may not land exactly on the number, but 11-count and 14-count are 12 squares apart over 10 cm, so you cannot mix them up.
Telling them apart by eye is harder than it sounds. Next to each other, 11-count looks chunkier, with bigger holes. On its own, a piece can fool you, so count.
Evenweave and linen: count threads, then halve
First check which fabric you have. Aida has clear blocks with a hole at each corner. Evenweave and linen look like plain cloth made of single threads, one over, one under. Aida, evenweave and linen compared shows how they differ to stitch on.
On evenweave or linen, count the threads in one inch the same way: that number is the count, so 28 threads is 28-count. Because you usually stitch over 2 threads, 28-count gives 14 stitches to the inch, the same as 14-count Aida, and 32-count gives 16.
The threads are fine, so it is easier to count over 2 inches and halve the answer. Linen’s threads vary a little in thickness, and some linens have a few more threads one way than the other. Count in several places and both directions, and go with the number you get most often.
What the count changes
The count does not change how many stitches a pattern has. It changes how big each stitch is, and so how big the finished piece is. Finished size is the stitches divided by the count, in inches.
- Size: a design 100 stitches wide is 23.1 cm (9.1 in) on 11-count and 18.1 cm (7.1 in) on 14-count. On 11-count everything comes out more than a quarter bigger each way.
- Fabric: a bigger design needs a bigger piece, plus 7.5 cm (3 in) spare on every side for a hoop and framing.
- Strands: stitchers usually use 3 strands of floss on 11-count and 2 on 14-count, so the crosses cover the squares.
- Thread: bigger stitches use more. One skein does about 1,000 full stitches on 11-count with 3 strands, and about 1,950 on 14-count with 2.
To see what a whole pattern needs, put its size and your count into the fabric calculator. If you are choosing a count rather than identifying one, see which fabric count suits your skill level.
Label it so you never measure twice
Once you know the count, write it down where you will see it: on the bag you keep the fabric in, or on a tag pinned to a corner. Note the type too (Aida, evenweave or linen) and the colour name if it came with one.
Tip: Masking tape on the edge of the fabric is a handy label, but take it off before it has been there for years: old tape can leave a sticky mark. Keep long-term labels on the bag instead.
For more ways to keep fabric sorted with your threads and patterns, see how to organise your stash.
Crosserly is a free cross stitch pattern maker. Turn a photo or a few words into a chart in real thread colours, or draw your own, then print it or follow it on your phone.
Questions
Which is bigger, 11-count or 14-count?
11-count has bigger squares, so the same pattern comes out bigger on it. A design 140 stitches wide is about 32.3 cm (12.7 in) on 11-count and 25.4 cm (10 in) on 14-count.
Is 28-count the same as 14-count?
For size, yes, when you stitch over 2 threads: 28 threads an inch over 2 gives 14 stitches an inch, like 14-count Aida. The fabric looks and feels different, though, because 28-count is evenweave or linen, made of single threads rather than blocks.
How can I measure fabric count without a ruler?
Use something with a known size, such as a bank card, which is 8.56 cm (3.37 in) wide on its long side. Count the squares along that edge: about 47 means 14-count and about 37 means 11-count.
Read next
- What Fabric Count Is Best for Your Skill Level?: Which count to stitch on as a beginner, an improver and an experienced stitcher, how the count changes the size of a pattern, and how many strands to use.
- Best Fabric for Cross Stitch Beginners: Aida vs Linen: Aida, evenweave and linen compared for a first project: how each is woven, how it feels to stitch, what it costs, and when to make the move to linen.
- How to Organise Your Floss Stash and Supplies: Bobbins, boxes, rings and lists: simple ways to sort your floss, keep track of what you own, store fabric and patterns, and stop buying the same thread twice.
All blog posts · Guides: Photo to pattern guide · Cross stitch app for beginners · PDF charts on iPhone